ASTM D4716 PDF
GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||14 February 2005|
|PDF File Size:||19.29 Mb|
|ePub File Size:||2.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing.
If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. Competent statistical assistance is recommended for the investigation of bias.
ASTM D4716 Geosynthetic in-Plane Water Flow Rate Tester
The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Inquiry Sent Successfully Confirmation email has been sent: As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For the best results, we recommend including the following details: Forward Filter Manufacturers Co. Please reply me within 24 hours.
Your email address is incorrect!
Your message must be betweencharacters! Enter your email please. Referenced Documents purchase separately The aastm listed below are referenced within the subject standard but are not provided as part of the standard. I would like your verified suppliers matching service!
Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
Products – BT Technology
Please reply me widthin 24 hours. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Link to Active This link will always route to the current Active version of the standard. Combining values from the atm systems may result in non-conformance with the standard. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.
Please enter 20 to characters to contact this supplier! Comparative tests as directed in 5. Send your message to this supplier.
Active Risk Management
Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. Your message has been sent to the following suppliers. Site Member 3 Years. The flow atm water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces. Recommended Quality Verified Suppliers.