View and Download Hach Sc E instrument manual online. Analysis System. Sc E Measuring Instruments pdf manual download. Hach Sc Controller User Manual – Download as PDF File .pdf), Text File .txt) or read online. Hach Sc Controller User Manual . Hach Company, – .. 37 W with 25 W sensor/network card load 24 VDCpowered sc model: 24 VDC.

Author: Goltijind Maujinn
Country: Jordan
Language: English (Spanish)
Genre: Art
Published (Last): 11 November 2007
Pages: 53
PDF File Size: 7.70 Mb
ePub File Size: 13.72 Mb
ISBN: 559-1-15727-187-4
Downloads: 73126
Price: Free* [*Free Regsitration Required]
Uploader: Nikobei

Page 16 Installation 3. Page 26 Installation 3. In the event that a defect is discovered during the warranty period, Hach Company agrees that, at its option, it will repair or replace the defective product or refund the purchase price, subject to the pro-rated schedule above, excluding original shipping and handling charges.

Theory Of Operation General Information 2. Section 5 System Startup 5.

Strip the insulation on the cable back 1-inch. Please contact the Hach Service Center serving your location.

Controller Display Features Operation 4. Failure to do so could result in serious injury to the operator or damage to the equipment.


Page 18 Installation s100. Table of Contents Section 5 System Startup Pipe vertical or horizontal 5. The warranty period for instruments is 24 months. Index A K Alarms The frequency will depend on the nature and concentration of dissolved and suspended solids in the sample.


Seat insulation against connector with no bare wire exposed. Section 2 General Information 2. Instrument Setup Operation 4.

What’s missing? Tell us about it.

Rinse with deionized water before calibrating. Printed in the U. Page 38 Operation 4. Page 33 Operation 4. Refer to Figure 29 and sx100 the following steps to replace the fuses: Appendix A Modbus Protocol A.

The non-sensor end is connected sc1000 the controller as described in section 3. Page 12 Installation 3. Your manual failed to upload To ensure that the protection provided by this equipment is not impaired, do not use or install this equipment in any manner other than that specified in this manual. Push in and turn to secure the connection.

Open the controller cover.

Hach-Lange SC 100 User Manual

Table of Contents Section 5 Maintenance DANGER Do not replace any component unless power to all electrical circuits to the Controller have been switched off and the area is known to be non-hazardous. Page 58 Index Index Sample Line Installation Problem resolution and fuse replacement should only be performed by qualified service personnel. In the United States: Figure 22 Front of the Controller 1 sc 5 2 6 3 7 4 1.


Failed fuses are an indication that an equipment problem could exist. Page 36 Operation 4. The turbidimeter sensor must be mounted within six feet of the controller unless an extension cable is used.

Replacing The Lamp Assembly Section 4 Operation 4. For more safety information refer to Safety Information on page 5. Specifying The Displayed Language Operation 4. Section 4 Operation Section 4 Operation 4. By pressing ‘print’ button you will print only current page. Pass the cable through conduit and a conduit hub or a strain relief fitting and an available access hole in the controller enclosure.

Hach-Lange SC : Owner manual

Enter text from picture: Page 7 Section sc10 Specifications Specifications are subject to change without notice. Section 1 Specifications Section 1 Specifications Specifications are subject to change without notice. Turbidimeter Installation Information Installation 3. Section 6 Replacement Parts 6. Wire as shown in Table 5. Or point us to the URL where the manual is located.