IMHS CP SURGICAL TECHNIQUE PDF
The technique description herein is made available to the healthcare professional .. to surgeon preference and/or fracture pattern. IMHS CP Nail Extractor. Surgical Technique. International Version. Page 2. Page 3. Nota Bene. The technique description herein is made available to the healthcare professional to illustrate the . enhanced sliding and compression of the IMHS™ IMHS™ CP Nail. Patient positioned with operative extremity adducted for intramedullary nailing. Distal interlocking of these longer nails requires a freehand technique. models of each of these devices have been introduced—Gamma III and IMHS CP.
|Published (Last):||13 May 2006|
|PDF File Size:||13.94 Mb|
|ePub File Size:||8.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Captured Compression Screw 19mm Cat. Remove the Trocar and replace with the 3. Expert Hindfoot Arthrodesis Nail. For minimally invasive osteosynthesis.
IMHS CP Clinically Proven Intramedullary Hip Screw Surgical Technique – PDF
The extremity is prepped and draped More information. The information contained in this document is intended for healthcare professionals only. At final seating, the T-Handle should be positioned perpendicular to the Drill Guide to properly orient the Lag Screw.
Check rotation by rotating the C-arm in line with the femoral neck anteversion and then making the appropriate correction, usually 0 15 of external rotation. The long nails expand indications to include comminuted neck and shaft fractures, and prophylactic nailings of impending pathological fractures.
No Cannulated Awl Cat. Visualize reaming with X-Ray to confirm that the Guide Pin is not being forced forward. No Torque Wrench Cat. Use the Obturator to prevent the Guide Pin from backing out as the reamer is removed. The nail is properly placed in the AP plane when the Guide Pin is seen on the Surgicall to be parallel to the neck and center in the femoral head.
IMHS CP Clinically Proven Intramedullary Hip Screw Surgical Technique
For limited sliding, orient the T-Handle parallel to the Drill Guide. It is inserted into the Telescoping Reamer Sleeve until it abuts the end of the sleeve.
Surgical Technique Table of contents Introduction No Lag Screw Tap Cat. If an implant has not been previously surgicwl, determine the following: Developed in conjunction with J.
Richards Smith & Nephew Imhs Instrument Sterilization Tray Case #2 Lid | eBay
Read the nail length from the calibrations exposed at the other end of the Ruler. Table of contents Indications and contraindications 3 Implants 4 Instruments 4 Preoperative planning More information.
No Trays Cat No. Instruments and implants approved by. Take the Lag Screw measurement by lining up the end of the 3. The rotation-stabilising More information. IMHS CP retains the clinically proven features of the original design while adding new features to simplify the procedure and provide more options for the surgeon to treat the indication that presents. Zimmer Natural Nail System. Make a 1 to 3cm incision that is approximately 3 to 6cm proximal to the greater trochanter.
Parallel T-Handle position limited sliding Perpendicular T-Handle position more sliding This illustration depicts an older design where the side plates have now been removed, as well as the mating holes for the Anteversion Locking Guide. Dedicated instruments for reconstructive foot surgery.
Image intensifier control Warning. No mm Short Hexdriver Cat. Russell, MD Roy W. Cerclage solutions for general surgery. To measure the length of the implant needed, ensure that the distal tip of the Ball-Tip Guide Rod is located at the desired position of the distal tip of the nail.
To help prevent sliding, tighten the Set Screw to two clicks with the T-Handle in the parallel position. The Compression Dial on the Insertion Wrench must also be set for added length.
The screw length measurement can be taken from the Drill Bit calibrations measured against the Black 3.
Richards Smith & Nephew 7115-2102 Imhs Instrument Sterilization Tray Case #2 Lid
No mm Guide Pin Cat. No Set Screw Driver Cat. Instruments and implants approved by More information. For ttechnique of fractures where the medullary canal is narrow or flexibility of the implant is paramount.
Lateral cortex over drilling optional When distally locking especially in diaphyseal bone it may be desirable to over drill the lateral cortex with the optional 4.
Check depth on AP X-Ray to ensure that the widest part of the c has reached the level of the lesser trochanter and has sufficiently opened the canal.